Siemens AC75 Manual De Usuario

s

AC75_ATC_V01.002

Page 436 of 569

10/30/06

Confidential / Released

Type of address octet, which defines the used type of number (ton) and the numbering plan identification (npi).

Please consider that for types other than 129 or 145 dialing from phonebook with 

 is, depending

on the network, not always possible (refer to GSM 04.08 subclause 10.5.4.7 for details). See also 

. 

Possible values are: 
145

Dialing string 

 includes international access code character '+'

161

National number. Network support of this type is optional.

209

 has been saved as ASCII string and includes non-

digit characters other than "*", "#" or "+". Note that phonebook entries saved

with this type cannot be dialed. 

255

 is a command to control a Supplementary Service,

i.e. "*", "#" codes are contained. Network support of this type is optional.

129

Otherwise

Text assigned to a phone number. The maximum length for this parameter is given with test command response

parameter 

. 

If using an ASCII terminal characters which are coded differently in ASCII and GSM have to be entered via

escape sequences as described in Section 

. 

Maximum location number for the currently selected storage. For phonebooks located on the SIM this value

depends on the SIM card type. 

Maximum length of phone number for "normal" locations. Depending on the storage a limited number of loca-

tions with extended memory is available per phonebook. These locations allow storing numbers with twice the

standard length, which is 2*

 digits for normal numbers, but only 

 digits for numbers

saved with 

=209. 

Maximum length of 

 assigned to the telephone number. The value indicated by the test command is

given in octets. If 

 is given as GSM characters each character corresponds to one octet. If the 

string is given in UCS2, the maximum number of characters depends on the coding scheme used for the alpha

field of the SIM according to GSM 11.11, Annex B 

. In the worst case the number of UCS2 characters is at

least one less than half the number of GSM characters. 

• Users should be aware that when using this AT command quickly after SIM PIN authentication the SIM data

may not yet be accessible, resulting in a short delay before the requested AT command response is returned.

See Section 

 for further detail. 

<type>

(num)

<text>

(str)(+CSCS)

<maxloc>

(num)

<nlength>

(num)

<tlength>

(num)