Gateway E-3200 Manual De Usuario
Getting Started 7
Starting Your System
Before you start your system for the first time:
•
Check that the voltage selector switch on the back of the computer
is still set to the correct voltage for your area. This switch is set at
the factory to the correct voltage (see “Rear Panel” on page 16 for
voltage selector switch location).
is still set to the correct voltage for your area. This switch is set at
the factory to the correct voltage (see “Rear Panel” on page 16 for
voltage selector switch location).
•
Make sure all cables are firmly connected to the proper cable ports
on the rear panel of the computer.
on the rear panel of the computer.
•
Make sure the computer and monitor are plugged into an AC outlet
or power strip.
or power strip.
1.
If you have connected the system components to a power strip, make
sure all the system components are turned off, and then turn on the
power strip.
sure all the system components are turned off, and then turn on the
power strip.
2.
Press the power button on the monitor to turn on the monitor.
3.
Press the power button on the computer to turn on the computer. The
power light-emitting diode (LED) on the front panel is lit when the
computer’s power is on.
power light-emitting diode (LED) on the front panel is lit when the
computer’s power is on.
4.
Turn on any other components connected to the computer, such as
speakers, a printer, or a scanner.
speakers, a printer, or a scanner.
5.
If nothing happens when you turn on the system:
To start the system
Power button
Power LED