Frye WinCHAP ver. 2.82 Manual De Usuario
106
The NOAH 3 Module
WinCHAP User’s Manual
Figure 8.2.1.1
8.2.1.2 To install the NOAH 3 Module from NOAH 3.
We recommend using the installation method specified in Section 8.3.1.1, but
you can also use the following method.
you can also use the following method.
1. Open NOAH 3.
2. Open the Tools menu and point at
2. Open the Tools menu and point at
Setup.
3. Select Install Module. This will bring up the Module Installation window.
4. Click Install.
5. Open the NOAHModule directory in the WinCHAP directory. On most
4. Click Install.
5. Open the NOAHModule directory in the WinCHAP directory. On most
computers, this will be: C:\Program Files\Frye Electronics\WinCHAP\
NOAHModule
NOAHModule
6. Select install.ini and click
Open. This will install the WinCHAP NOAH
module.
8.2.2 Opening the WinCHAP NOAH Module
1. Select a client in the Client Register window.
2. Click
2. Click
, the Open Module Selection button.
3. Select the Measurement tab.
4. Select Frye Electronics. This will open the WinCHAP Module. See Figure
4. Select Frye Electronics. This will open the WinCHAP Module. See Figure
8.3.
8.2.3 Selecting the WinCHAP database and executable
When installing the NOAH module, it should automatically figure out where
the WinCHAP executable and database files are located. If for some reason this
doesn’t work, you can set these locations manually.
the WinCHAP executable and database files are located. If for some reason this
doesn’t work, you can set these locations manually.
1. Open the Frye Tools menu.
2. Point at Settings and select Set WinCHAP Database
2. Point at Settings and select Set WinCHAP Database