Cobra Electronics Classic LT Manual De Instrucciónes

 TM    

www.cobrausa.com 

 TM

 
 

1 – Assembled Lightbar 

2 – Spacer, Aluminum .375” long 

3 – Cable Ties 4” Black 18# Test 

1 – Wire Quick Splice Connector 

2 – Terminals, 16 gage Crimp 

1 – Wire 18 gage Black 20” Length 

KAWASAKI VN 900 / CLASSIC LT 

2006 

 

1.  Remove (2) Phillip head screws from headlight and set aside.  Remove headlight from housing, 

unplug and set aside. 

2.  Unplug turn signals inside headlight housing.  Remove the (2) M8 and (2) M6 bolts from turn signal 

bar and set bolts aside.  Remove (2) M10 nuts from turn signals and remove from bar.  Set M10 nuts 
and turn signals aside. 

3.  Install your new Cobra lightbar by inserting the (2) M6 bolts removed from Step 2 into the stock 

mounting location and snug.  Insert the M8 bolts removed in Step 2 through outside mount, provided 
aluminum spacers and into stock mounting location.  Align Lightbar and tighten bolts to factory torque 
specifications. 

4.  Install Left turn signal (Black disconnect) in the same manner in which it was removed with M10 nut 

set aside from Step 2.  Repeat with Right turn signal (Gray disconnect.)  Route wires through back of 
headlight and reconnect to proper colored connectors. 

5.  Route the left spotlight wire under the lightbar towards the lightbar switch, take the right spotlight wire 

and twist together with the left one.  Insert the two (twisted together) wires into the supplied push on 
terminal and crimp with a crimping tool.  Connect this to one of the poles on the lightbar switch, it does 
not matter which one. 

6.  Connect the 20” power wire to the remaining pole on the lightbar switch.  Route the power wire 

through the back of the headlight housing.  Loosely pull slack out of wire and using the 3 supplied zip 
ties wrap spotlight, turn signals, and power wire to the lightbar. 

7.  Locate the 3 wire accessory lead with the flat 3 –wire connector inside the headlight housing.  

Connect the Black power wire from the lightbar switch to the Red with Blue tracer wire using the 
supplied blue quick splice connector. 

8.  Reinstall the headlight with (2) Phillips screws removed in Step 1. 

9.  Check to make sure your handlebars turn from lock to lock without any stretching or binding in any of 

the wires.  Check the alignment of all your lighting.  Make sure everything is in proper working order 
before riding the vehicle.