Bunn FPG-2 Manual De Usuario

54

FIG 60 EMI FILTER

FIG 61 EMI FILTER TERMINALS

Location:
 

The EMI Filter is located inside the rear cover of the 

grinder housing.
Test Procedure:

1.  Disconnect the dispenser from the power source.

2.  Disconnect the two red wires and two white wires on 

the EMI Filter from the EMI Filter wiring harness.

3.  Check for resistance between the two red leads on 

the EMI Filter. (Fig 61)   

If resistance is present as described the EMI Filter is 

operating properly.

If resistance is not present as described, replace the 

EMI Filter.

Removal and Replacement:

1.  Disconnect the wires from the EMI Filter.

2.  Remove the two screws securing the EMI Filter.

3.  Remove and discard EMI Filter.

4.  Install new EMI Filter using two screws to secure 

EMI Filter to its former location.

5.  Refer to schematic when reconnecting the wires.

118.0 kΩ - 118.5 kΩ

Across either pair

41545 122209