Amana AGK01 Instruccion De Instalación

11

No holes are permitted

in chassis basepan or

wallsleeve when routing

low voltage wire. Route the

low voltage wires through

the indention on the front

of the basepan.

The vent control allows outside air to be drawn into the condi-

tioned area. This outside air can provide ventilation when the

blower is operating, but it will increase the heating or cooling load

and operating costs.

To obtain access to the vent control:

1.

Remove the cabinet front (see Front Removal).

2.

Remove the shipping screw (if installed) from the vent door.

3.

Remove the label (if present) from over the vent control lever
on the left side of the chassis.  Remove the vent door ship-
ping screw.

4.

Rotate the vent control lever to either open or close the
damper.

Vent
Closed

Vent
Open

To avoid the risk of freezing the steam or water coil during

prolonged shut down periods, the vent door must be left closed

when the outdoor temperature might fall below freezing.

The discharge grille can be adjusted to expel air at either a 15° or

40° angle.

Use the following procedure to change the angle of the discharge

air flow:

1.

Remove the front cabinet (see Front Removal).

2.

Position the front so that the backside is accessible (see fig-
ure below).