DCS ADR2 Guía De Instalación Rápida
Important!
Do not use abrasive cleaners, steel soap pads or sharp objects on
stainless steel.
stainless steel.
Note: Stainless steel tends to corrode in presence of chlorides and
sulfides especially in coastal areas. To ensure corrosion prevention,
wash all stainless steel surfaces every 3-4 weeks with fresh water and
stainless cleaner.
sulfides especially in coastal areas. To ensure corrosion prevention,
wash all stainless steel surfaces every 3-4 weeks with fresh water and
stainless cleaner.
These stainless steel products are made of mold resistant materials.
However, to avoid staining or growth of mold, always empty, clean and
dry your product(s) when not in use.
However, to avoid staining or growth of mold, always empty, clean and
dry your product(s) when not in use.
Always use the mildest cleaning procedure first.
Wipe soiling off with a cloth using a mild household detergent and
wipe dry with a clean cloth.
wipe dry with a clean cloth.
Regularly clean the drawers using hot soapy water. Rinse and dry with
a clean soft cloth to avoid water marks.
a clean soft cloth to avoid water marks.
To maintain the exterior appearance, apply a stainless steel polish to
the outside surfaces on a regular basis.
the outside surfaces on a regular basis.
Always read the label of your stainless steel cleaner to ensure it does
not contain chlorine compounds.
not contain chlorine compounds.
Always rub the stainless steel in the direction of the grain.
Drawer maintenance
To maintain the smooth operation of the drawers, spray the bearing
areas with silicone spray lubricant annually.
areas with silicone spray lubricant annually.
CARE AND CLEANING
FOR MORE INFO
590616B 11.14
For warranty information
see your ‘Service and warranty’ booklet
see your ‘Service and warranty’ booklet or contact us
toll-free, 24/7
1 888 936 7872
www.dcsappliances.com
www.dcsappliances.ca
If you…
have any questions or comments
need a DCS by Fisher & Paykel authorized
technician to service your product
need replacement parts or accessories
want to register your product
Lubrication points
(use silicone spray
annually)
(use silicone spray
annually)
REMOVING DRAWERS (SOME PRODUCTS ONLY)
REPLACING DRAWERS (SOME PRODUCTS ONLY)
To remove the drawer(s)
1
Remove the drawers by pulling them
out until the slider latch is visible.
out until the slider latch is visible.
2
Carefully push the latch down on the
left side, while lifting up the latch on
the right side.
left side, while lifting up the latch on
the right side.
3
Pull the drawer out of the frame.
Note: to prevent damage to surfaces, place
the drawers on a stable surface on a
protective towel or table cloth.
the drawers on a stable surface on a
protective towel or table cloth.
To replace the drawer(s)
1
Extend both guide rails out.
2
Engage the drawer rails into the guide
rails. Pull the guide rails forward until
they ‘click’ into place.
rails. Pull the guide rails forward until
they ‘click’ into place.
3
Push the drawer all the way in (there
will be some resistance) to completely
engage the drawer.
will be some resistance) to completely
engage the drawer.
Note: drawers in all products except
for the pantry unit are “soft closing”.
for the pantry unit are “soft closing”.
Left Slider latch
Extend guide rails
Engage drawer rails
Right Slider latch