Gaggenau VG491210CA Instruccion De Instalación
12
Installation Procedure
Install Appliance
9
WARNING
Before you plug in an electrical cord or turn on
power supply, make sure all controls are in the
OFF position.
power supply, make sure all controls are in the
OFF position.
1
Tighten the threaded rods on all four sides of the
cooktop.
cooktop.
9
CAUTION
If a nozzle change is required, only tighten
the threaded rods after you have changed
the nozzles!
the threaded rods after you have changed
the nozzles!
2
Hold the holding plate against the front panel
from the rear. Insert the control knobs in the
holes from the front and screw them down from
the rear with the nuts. Pay attention to correct
assignment of the control knobs (see figure).
from the rear. Insert the control knobs in the
holes from the front and screw them down from
the rear with the nuts. Pay attention to correct
assignment of the control knobs (see figure).
3
Evenly insert the unit in the cut-out. Press the unit
firmly into the cut-out from above.
firmly into the cut-out from above.
Note: The unit must sit firmly in the cut-out and
must not move (e.g. during cleaning). If
necessary, secure strips at the sides in the cut-
out if the cut-out width is at the top tolerance
limit.
must not move (e.g. during cleaning). If
necessary, secure strips at the sides in the cut-
out if the cut-out width is at the top tolerance
limit.