Dacor DYWS4 Manual

7

Preparing to Use Your Wine 

Dispenser for the First Time

Do not use any power supply other than the one provided 

with the system or a Dacor approved replacement. Do 

not attempt to modify or bypass the power supply.

1.  If not already connected, plug one end of the 

plastic gas tubing (provided) into the inert gas 

connector at the back of the wine dispensing 

system.

2.  Make sure the cable coming from the power 

supply (opposite the power cord that connects 

to the wall) is connected to the Power Input 

connector on the back of the unit. Also, check 

to make sure that both of the micro-switches 

located on the back of the unit are in the up 

position.

3.  plug the power cord (provided) into the power 

plug on the power supply (black rectangular 

box) mounted on the back of the wine dispens-

ing system.

4.  Slowly and gently lift the unit up and into the 

final location. Exercise care to make sure that 

the wiring and tubing lines do not become dam-

aged. Make sure the required 1" (2.5 cm) space 

is maintained above and below the unit.

Setting Up Your Wine Dispensing System

Plastic gas 

tubing

Connect power 

supply output 

here

120 Vac 

power cord

Connect to 120 Vac, 60 Hz. 

electrical outlet

These connectors 

for use by qualified 

service personnel only 

Inert gas 

connector

Power 

supply

5.  Open the door on the front of the unit. Swing the 

spout cover to the up position as shown on the 

facing page. 

6.  Make sure the power switch, located on the left 

side of the bottle bay, is slid all the way down, to 

the OFF position.

7.  Lower the spout cover by pushing up and hold-

ing the lever on the bottom as you lower it 

down. See diagram on bottom of page 8. 

CAUTION: Do not push down on the spout 

cover without pushing up on the lever. Damage 

to the lever will result.

8.  Once the spout cover is closed, close the bottle 

bay door. push in slightly just above the lock 

until it snaps shut.

 

 

   continued...

ON

OFF