Gaggenau VG231214CA Instruccion De Instalación
6
Technical Data
Total connected load electric: 0.8 VA
Installation Procedure
Prepare Installation Space
Create the cut-out in the counter top for one or several
Vario appliances according to the installation diagram.
The angle of of the cut sur face to the counter top must
be 90°.
Vario appliances according to the installation diagram.
The angle of of the cut sur face to the counter top must
be 90°.
After creating cut-out, remove shavings. Seal cut
sur faces in a heat-resistant manner.
sur faces in a heat-resistant manner.
Some solid sur face counter tops require special
installations. For example, heat reflective tape and
rounded corners may be necessar y. Contact the
countertop manufacturer for instructions specific to
your counter top.
installations. For example, heat reflective tape and
rounded corners may be necessar y. Contact the
countertop manufacturer for instructions specific to
your counter top.
Obser ve minimum distance between appliance
underside and furniture par ts of
underside and furniture par ts of
3
/
8
" (10 mm).
When installing multiple Vario appliances:
Take into
account space requirement for VV 200 connection
strip between the appliances. Appliances can also be
installed in individual cut-outs, bearing in mind a
minimum distance between the appliances of 1
strip between the appliances. Appliances can also be
installed in individual cut-outs, bearing in mind a
minimum distance between the appliances of 1
9
/
16
"
(40 mm).
Install Appliance
,
WARNING:
Before you plug in an electrical cord
or turn on power supply, make sure all controls
are in the OFF position.
are in the OFF position.
1
Make a mark exactly in the center of the cut-out.
Fasten the mounting rails to the front and rear
edge of the cut-out. The leading edges of the
mounting rails must lie upon the worktop. The
center marking of the mounting rails must
correspond precisely with the center marking of
the cut-out.
Fasten the mounting rails to the front and rear
edge of the cut-out. The leading edges of the
mounting rails must lie upon the worktop. The
center marking of the mounting rails must
correspond precisely with the center marking of
the cut-out.
Note:
For natural stone worktops, adhere the
mounting rails with temperature-resistant duel-
component adhesive (metal on stone).
component adhesive (metal on stone).
2
For combination with the VD 201 device cover:
Mount device cover to device prior to installation
(see VD 201 Installation Instructions).
Mount device cover to device prior to installation
(see VD 201 Installation Instructions).
3
Inser t device in cut-out. The latching lugs on the
device must lie precisely on the clamp springs.
Press device firmly into the cut-out.
device must lie precisely on the clamp springs.
Press device firmly into the cut-out.
The latching
lugs on the device must snap into the clamp
springs.
springs.
Gas
Natural Gas
Type N
Type N
LPG (Propane)
Type X
Type X
Pressure
6" water
column
(1.5 kPa)
column
(1.5 kPa)
10" water
column
(2.5 kPa)
column
(2.5 kPa)
C
Nozzle, full burn, outer
173
110 A
A
Nozzle, low burn, outer
79
57
D Nozzle, full burn, inner
60
42
B Nozzle, low burn, inner
42
31
Air gap adjustment, outer
2 mm
0 mm
Total connected load
18 800 BTU
(5.5 kW)
(5.5 kW)
17 000 BTU
(5 kW)
(5 kW)
Total consumption
0.52 m³/h
364 g/h