Sunpentown SD31E Hoja De Datos
5
Other Features
•
Bucket Full Light: Illuminates when the bucket is full and needs to be emptied; or when
bucket is removed or not properly seated.
bucket is removed or not properly seated.
•
Auto Shut Off: The unit shuts off after 30 seconds when bucket becomes full or when
bucket is removed / not properly seated; or when set humidity is reached (the fan motor will
continue to run for additional 3 minutes then stop).
bucket is removed / not properly seated; or when set humidity is reached (the fan motor will
continue to run for additional 3 minutes then stop).
•
Auto Defrost: When frost builds up on the evaporator coils, the compressor will cycle off
and the fan will continue to run until the frost disappears.
and the fan will continue to run until the frost disappears.
•
3 Minute Delay: After the unit has stopped (or powered off), there will be a 3-minute delay
before it will resume operation again. This is to protect the compressor. Operation will
automatically start after 3 minutes.
before it will resume operation again. This is to protect the compressor. Operation will
automatically start after 3 minutes.
•
Check Filter Feature: The system begins calculating the time once fan motor begins
operation. The check filter feature will be activated when operation time achieves 250 hours
or more - the clean filter indicator light will begin to flash. After filter has been cleaned and
replaced, press the Filter button to reset and the clean filter indicator will go off.
operation. The check filter feature will be activated when operation time achieves 250 hours
or more - the clean filter indicator light will begin to flash. After filter has been cleaned and
replaced, press the Filter button to reset and the clean filter indicator will go off.
•
Auto-Restart: If the unit breaks off unexpectedly due to power cut, unit will resume at
previous setting when power returns.
previous setting when power returns.
•
Timer On and Timer Off: Unit can be set to auto-start/stop, up to 24 hours:
o
When unit is on: press of the Timer button and the Timer-Off indicator will illuminate
(indicating auto-stop is initiated). Press Timer button again and the Timer-On indicator
will illuminate (indicating auto-start is initiated).
(indicating auto-stop is initiated). Press Timer button again and the Timer-On indicator
will illuminate (indicating auto-start is initiated).
o
When the unit if off: press of the Timer button and the Timer-On indicator will illuminate
(indicating auto-start is initiated). Press Timer button again and the Timer-Off indicator
will illuminate (indicating auto-stop is initiated).
(indicating auto-start is initiated). Press Timer button again and the Timer-Off indicator
will illuminate (indicating auto-stop is initiated).
o
Press or hold the +/- buttons to change the set time in 0.5-hour increments, up to 10
hours; then in 1-hour increments, up to 24 hours.
hours; then in 1-hour increments, up to 24 hours.
o
The selected time will register after 5 seconds and the panel will revert back to
displaying ambient humidity.
displaying ambient humidity.
o
When both auto-start and auto-stop times are set, both Timer On and Off indicator lights
are illuminated, identifying both On and Off timers are now programmed.
are illuminated, identifying both On and Off timers are now programmed.
o
Turning the unit on or off at any time or adjusting the timer setting to 0.0 will cancel any
timer programs.
timer programs.
o
Timer program is also cancelled when LED displays P2 error code.
o
The control will count down the remaining time.