Gaggenau DF281760 Manual De Propietario
40
en-us Troubleshooting
Silverware not dry.
Silverware not arranged properly in
the silverware basket.
the silverware basket.
Separate silverware if possible, prevent
contact points.
contact points.
Silverware not arranged properly in
the third rack.
the third rack.
Arrange silverware properly and separate if
possible.
possible.
Appliance interior wet after rinse
cycle.
cycle.
No appliance fault.
On account of the “Condensation drying”
principle, water droplets are physically
induced and required in the container. The
humidity in the air condenses on the inner
walls of the dishwasher, drains and is
pumped out.
principle, water droplets are physically
induced and required in the container. The
humidity in the air condenses on the inner
walls of the dishwasher, drains and is
pumped out.
Food soils on the dishes.
Dishes placed too closely together,
racks overfilled.
racks overfilled.
Arrange dishes with adequate clearance
between them ensuring that the spray jets
can reach the surface of the dishes. Prevent
contact points.
between them ensuring that the spray jets
can reach the surface of the dishes. Prevent
contact points.
Spray arm rotation obstructed.
Arrange dishes so that the spray arm can
rotate without obstruction.
rotate without obstruction.
Spray arm nozzles are blocked.
Clean the spray arm nozzles.
Filters 1Z dirty.
Clean filters.
Filters 1Z inserted incorrectly
and/or not engaged.
and/or not engaged.
Insert and engage filters correctly.
Rinse wash cycle too weak.
Select a more intensive rinse cycle.
Increase sensitivity of the sensors.
Increase sensitivity of the sensors.
Dishes precleaned too intensely;
sensors therefore decide on weak
wash cycle sequence. Stubborn
soiling cannot be completely
removed.
sensors therefore decide on weak
wash cycle sequence. Stubborn
soiling cannot be completely
removed.
Do not prerinse dishes. Remove only large
food soils.
Increase sensitivity of the sensors.
Recommended wash cycle "Regular" or
Intensive.
food soils.
Increase sensitivity of the sensors.
Recommended wash cycle "Regular" or
Intensive.
Tall narrow containers in corner
areas are not rinsed adequately.
areas are not rinsed adequately.
Do not place hollow containers too
obliquely and do not place in the corner
area.
obliquely and do not place in the corner
area.
Upper rack 12 on right and left not
set to same height.
set to same height.
Set upper rack to same height using side
levers.
levers.
Dishwasher seems to run a long
time
time
Incoming water is not warm enough. Before starting a cycle, run hot water faucet
at the sink closest to the dishwasher.
Cycle time can vary due to soil and
water conditions.
water conditions.
Sensors in the dishwasher automatically
increase the cycle time to ensure a good
wash when heavy soil is detected.
increase the cycle time to ensure a good
wash when heavy soil is detected.
Rinse aid dispenser 9" is empty.
Add rinse aid.
Dishwasher connected to cold water
supply.
Note:Check the typical wash cycle
length.
supply.
Note:Check the typical wash cycle
length.
Verify dishwasher is connected to hot water
supply plumbing.
supply plumbing.
Fault
Cause
Remedial action