Houzer CVT16451 Instruccion De Instalación

1. Unpack the new sink and check the contents of the materials supplied: (1) sink, 
   Mounting brackets, cutout template.

2. Supplied cutout template provides two installation options.

Topmount (Drop-in) installation 

Undermount installation

3. Place the template in desired position on countertop, locating center of the bowl 
   over cabinet and faucet holes.

4. Trace the outline of the template and cut countertop along the inside of the line using 
   appropriate tools. Template is for guide only. Use physical sink to ensure accurate cutout 
   opening. Attach faucet and drain fitting as necessary at this point according to the mfr’s 
   instructions.

5. Topmount (drop-In ) Installation (Figure 1) 
   Apply adhesive caulk sealant (not furnished) around the 
   underside of the rim. Place the sink carefully, align and 
   press firmly around perimeter of the sink rim. 
   Allow sealant to set before proceeding. 

6. Undermount Installation (Figure 2)
6-1. Locate and drill holes on the underside of the countertop, 
       approximately 1” from edge of the sink rim to be installed. 
       Loosely attach mounting brackets to the underside of the
       countertop parallel to the cutout opening. (Depending on 
       the countertop materials, correct type of fasteners may be
       recommended by your installer or supplier) (Figure 3)

6-2 Apply adhesive caulk sealant (not furnished) 
      around the topside of the rim.  Allow sealant to
      set before proceeding. Place the sink from the 
      underside of the countertop carefully, align and 
      press firmly. 

6-3 Turn bent end of mounting bracket to snug 
      over the sink rim and tighten fasteners.
      (Figure 4)