Boss Audio BV7320 Manual De Usuario
1.7 Description of the Rear Cabinet
Connecting the parking brake li ne to th e parking brake system built in the car
Parking brake
Parking brake switch
(inside the car)
(inside the car)
Parking brake wires(Green)
To metallic body or chassis of the car
Reversal line White
Parking Line GREEN
Note:1. Park ing wire must be c onnected , and the park ing b rake mus t be engaged in order for the monitor to work
2. Use the clip e nd of the Ground wire provided by manufactur er to connect Mounting Scre w, us e the oth er
end of th e Ground wire to conne ct the negative pol e of t he p ower source. Otherwise, the video on scre en
may flac hes.
may flac hes.
Fixing Screw Bolt
Fixed ISO Female Connector
GRAY
GRAY
VIDEO OUT
YELLOW
YELLOW
BLACK
RED R
WHITE L
BLACK
FRONT RCA LINE OUT
SUBWOOFER
GREY
GREEN
GREY
GREY
RED R
WHITE L
REAR RCA LINE OUT
BLACK
USB LINE IN
It is for adjusting the hue of the video output.
It is for adjusting the saturation of the video output.
It is for adjusting the sharpness of the video output.
It is for selecting your desired sound effect when there is not central speaker
and sub-woofer. There are 3 mode: LT/RT, STEREO, VSS.
and sub-woofer. There are 3 mode: LT/RT, STEREO, VSS.
LT/RT: When playing a disc with PRO LOGIC Dolby stereo effect, choose the
item, so it will output audio signal with vivid theatre effect.
STEREO: If you choose the item, when outputting audio signal with 5.1 channels,
it will output the left and right channels of signal ; when outputting audio signal
with 2 channels, it will output the common 2 channels of stereo signal.
with 2 channels, it will output the common 2 channels of stereo signal.
VSS: If you choose the item, when playing a disc recorded with 5.1 channels,
the main channel speakers can output audio signal with VSS effect.
It is for selecting audio output mode
LINE OUT: It can linearly compress the audio signal. So the volume level is lower.
RF REMOD: It can make the volume level higher.
After selecting the compression mode of LINE OUT, set the item, so you can
adjust the linear compression ratio. If you set it to be FULL, the Peak-to-Peak
value of the audio signal is the minimum; if you set it to be OFF, the Peak-to-
Peak value is the maximum.
adjust the linear compression ratio. If you set it to be FULL, the Peak-to-Peak
value of the audio signal is the minimum; if you set it to be OFF, the Peak-to-
Peak value is the maximum.
It is for selecting a desired audio output mode for the left and right ways of signal.
There are 4 modes in all as follows: STEREO, MONO L, MONO R, MIX MONO.
There are 4 modes in all as follows: STEREO, MONO L, MONO R, MIX MONO.
HUE
SATURATION
SHARPNESS
5.19.5 SPEAKER SETUP
5.l9.6 DIGITAL SETUP
OP MODE
DYNAMIC RANGE
DUAL MONO
SPEAKER SETUP
DOWNMIX
DIGITAL SETUP
OP MODE
DYNAMIC RANGE
DUAL MONO
DYNAMIC RANGE
DUAL MONO
DOWNMIX
Rear View Camera
In any running mode, the video signal will switch to camera mode (if applicable)when car is in reverse.
After taking the car out of reverse, it will resume to its previous mode.
Analog on-site backup
Analog on-s ite backup
P I C
A N G L E
Warning:
Always check the surrounding environment. Objects might be reversed. The r ear view
camera is designed only to assist while reversing. Due to the lim itations of the camera
angle and range, it m ay cause accidents if the driver relies solely on the rever se camera
and disp lay.
Always check the surrounding environment. Objects might be reversed. The r ear view
camera is designed only to assist while reversing. Due to the lim itations of the camera
angle and range, it m ay cause accidents if the driver relies solely on the rever se camera
and disp lay.
PDF created with FinePrint pdfFactory Pro trial version