Whirlpool WSZ57L18DH-WH Instruccion De Instalación

1. Remove the four hex-head screws on each roller assembly. 

Set the roller assemblies aside.

2. Place the refrigerator/freezer on its back on top of a piece of 

cardboard or other protective material.

3. Insert two plastic leveler legs (M) into each cabinet.

4. Return refrigerator/freezer to an upright position. 
5. Adjust the leveler legs (M) so that each appliance is level, 

plumb and at the same height as the other appliance.
NOTE: Now, the freezer and refrigerator each have two front 
leveler legs (M) that are adjustable. The back of each cabinet 
rests on two fixed supports. 

6. Place a leveling tool on top of the cabinet. Check the level first 

side to side and then front to back.
To raise a corner - Turn the leveler leg clockwise. 

To lower a corner - Turn the leveler leg counterclockwise. 

7. Repeat Step 3 for the other appliance until both the freezer 

and refrigerator are level, plumb and at the same height.

IMPORTANT: If the electrical outlets are not centered in the back 
wall of the opening, move the appliance on the opposite side of 
the outlets into the opening first.
1. Cover the floor with cardboard or hardboard to avoid floor 

damage. 

2. Attach a plastic foam rear spacer (I) to the rear center of both 

appliances.
NOTE: The rear spacers (I) ensure that the 2 appliances are 
positioned the correct distance from the wall to avoid cabinet 
damage.

3. Slide the first appliance into the opening far enough to 

connect the power cord to the electrical outlet.

IMPORTANT: Wait 24 hours before plugging in your refrigerator 
or freezer to avoid compressor failure.

4. Plug into a grounded 3 prong outlet.

IMPORTANT: If the electrical outlets are not centered in the back 
wall of the opening, move the appliance on the opposite side of 
the outlets into the opening first.
1. Slide the second appliance into the opening far enough to 

connect the power cord to the electrical outlet.

IMPORTANT: Wait 24 hours before plugging in your refrigerator 
or freezer to avoid compressor failure.
2. Plug into a grounded 3 prong outlet.
3. If needed, either door may be adjusted horizontally by 

loosening the three hinge bolts, moving the hinge and 
retightening the bolts.
NOTE: Provide additional support for the refrigerator door 
while the hinges are being moved. Do not depend on the door 
gasket magnets to hold the door in place while you are 
working.

1. Insert one painted pan-head Torx

®†

 screw (L) through the top 

plate (D) and thread it into the cabinet. Use the two rear holes 
in each cabinet.
NOTE: Do not completely tighten the screw.

Your freezer and refrigerator are heavy. When moving the 
appliance for cleaning or service, be sure to cover the floor 
with cardboard or hardboard to avoid floor damage. Always 
pull the appliance straight out when moving it. Do not wiggle 
or “walk” the appliance when trying to move it, as floor 
damage could occur.

†®TORX is a registered trademark of Saturn Fasteners, Inc.