Whirlpool W10298318RP Instruccion De Instalación

Position the packaged washer or dryer close to its final position. 

cut the packaging as follows:

Washer: Cut plastic film along dotted cut line around the 

 

■

base. Remove the packaging. Do not remove the shipping 

bolts.
Dryer: Cut around top and down corners along dotted cut 

 

■

lines. Discard carton top, corner posts and sides. Leave 

carton bottom underneath dryer.

1. Unplug the power supply cord.
2. Turn off the gas supply.
3.  Pull the dryer away from the wall enough to loosen the vent 

clamp. Loosen the clamp and gently remove the exhaust vent 

from the dryer exhaust outlet.

4.  Disconnect the flexible gas supply line from the dryer. Put  

a piece of tape over the open ends of the gas line connection 

fittings.

Steam Models Only:
5. Turn off water faucet.
6.  Disconnect the water inlet hose from faucet, then drain the 

hose into a bucket.

imPoRtant: If your washer and dryer are already installed, they 

must be uninstalled. 

 

If you need to uninstall your washer or dryer, see “Installation 

Instructions” that came with your model for tools required.

1. Turn off the hot and cold water faucets.
2. Unplug the power supply cord.
3.  Slowly loosen the fill hoses at the faucets to relieve the water 

pressure. Use a sponge or towel to absorb the released water.

4.  Remove the “HOT” and “COLD” fill hoses from the back  

of the washer. Drain water in the hoses into a bucket.

5.  Remove the drain hose from the wall drain pipe or utility sink 

and drain any water in the hose into a bucket.

1. Unplug the power supply cord.
2.  Pull the dryer away from the wall enough to loosen the vent 

clamp. Loosen the clamp and gently remove the exhaust vent 

from the dryer exhaust outlet.

Steam Models Only:
3. Turn off water faucet.
4.  Disconnect the water inlet hose from faucet, then drain the 

hose into a bucket.