Whirlpool WSZ57L18DH-WH Manual De Propietario
5
Freezer Door
Tools Needed:
⁵⁄₁₆" hex-head socket wrench, ³⁄₈" hex-head socket
wrench, flat 2" putty knife.
IMPORTANT:
■
Depending on the width of the opening, you may need to remove
the handle or door to move the freezer into the house.
■
All graphics referenced in the following instructions are included
later in this section after “Final Steps.” The graphic may be reversed
if door swing is reversed.
■
Before you begin, turn the control OFF, and remove food and
adjustable door or utility bins from door.
Remove and Replace the Handle
To Remove the Handle:
1.
Loosen the setscrews located on the side of handle at each end.
See Handle graphic.
2.
Remove the handle from the grommets.
To Replace the Handle:
1.
Place the handle onto the grommets making sure the grommets
are fitted into the handle holes.
2.
Tighten the upper and lower setscrews with the hex key provided.
See Handle graphic. Do not overtighten the setscrews.
Remove Door and Hinges
1.
Unplug freezer or disconnect power.
2.
Keep the freezer door closed until you are ready to lift it free from
the cabinet.
NOTE:
Provide additional support for the door while the hinges are
being moved. Do not depend on the door magnets to hold the door
in place while you are working.
3.
Remove the parts for the top hinge as shown in Top Hinge graphic.
4.
Lift the freezer door free from the lower hinge and cabinet and set
aside.
5.
Remove the four hex-head hinge screws and bottom hinge
assembly. See Bottom Hinge graphic.
Replace Door and Hinges
NOTE:
Graphic may be reversed if door swing is reversed.
1.
Replace the parts for the bottom hinge as shown and tighten
screws. See Bottom Hinge graphic. Replace the freezer door.
NOTE:
Provide additional support for the door while the hinges are
being moved. Do not depend on the door magnets to hold the door
in place while you are working.
2.
Assemble the parts of the top hinge as shown in the Top Hinge
graphic. Do not tighten the screws completely.
Final Steps
1.
Check all holes to make sure that hole plugs and screws are in
place. Reinstall top hinge cover. See Top Hinge graphic.
2.
Using the provided decals, cover the remaining holes located on
the opposite side from the bottom hinge.
3.
Plug into a grounded 3 prong outlet.
4.
Reset the control. See “Using the Control.”
5.
Return all removable door parts to door and food to freezer.
Hex-head hinge screws
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
fire, or electrical shock.
WARNING