Crestron electronic 2-Series Control Processor Manual De Usuario

Crestron CP2/CP2E 

 

2-Series Integrated Control Processor

 

This male connector can be used to supply 24VDC power to the CP2/CP2E from an 
AC power pack purchased separately. (Refer to Optional Power Supply on page 13). 
When power is supplied to the units through this connector, 24VDC, 24W is also 
available to other Cresnet system devices through the NET connector. This is 
typically done in small installations. In large system configurations, power is usually 
supplied through Cresnet wiring to the NET connector.   

NOTE:  Use care in wiring installations to avoid applying 24 VDC power to Cresnet 
wiring from an AC power pack as well as from a system device that contains its own 
power supply. Although this condition should not cause any damage, Crestron does 
not recommend it. In those network configurations that require more power than can 
be supplied by Crestron’s Power Control Unit alone, disconnect the +24 VDC 
Cresnet wire from those devices that will be powered by an AC power pack. 

LAN (CP2E only) 

 

This built-in 10/100 BaseT Ethernet RJ45 port (CP2E only) provides local area 
network or Web access. Refer to the following table for the Ethernet connector 
signals and use an appropriate cable (not supplied). 

1 TD+ 
2 

TD- 

3 RD+ 
4 

Connected to pin 5 

5 

Connected to pin 4 

6 

RD- 

7 

Connected to pin 8 

8-Position 
RJ45 

8 

Connected to pin7 

 

NOTE:  Interface connectors for the NET, Infrared-Serial, I/O, and Relay Output 
ports are provided with the unit. 

The CP2/CP2E has 36MB of built-in memory (non-volatile and volatile). A total of 
36MB is broken down as follows: 4MB flash (non-volatile), 32MB DRAM 
(volatile), and 256KB NVRAM. Flash memory contains the file system inside the 2-

•  7