Crestron electronic 2-Series Control Processor Manual De Usuario

2-Series Integrated Control Processor 

 

Crestron CP2/CP2E

 

 

After you convert each module in a program, you can convert the program as 
described previously: drag the CP2 or CP2E onto the existing control system in 
System Views and click Yes to confirm the replacement. 

For further information about compile-time errors and detailed explanations about 
working with modules, refer to the SIMPL Windows online help file. 

Before uploading a program to the CP2/CP2E or performing diagnostic functions, 
you must connect the control system to the PC. With the CP2, this connection must 
be serial; with the CP2E the connection can be either serial or TCP/IP. 

Connect the COMPUTER port on the control system to one of the COM ports 
(usually COM 1) on the PC. Use a straight-through RS-232 cable with a DB9 male 
connector on one end and a DB9 female connector on the other. Most commercially 
available cables are acceptable; they should have at least 5 pins for transmit, receive, 
ground, and hardware handshaking.  

Open the Crestron Viewport and click Setup | Communication Settings to display 
the “Port Settings” dialog box. Then click RS-232 as the connection type. 

The PC communication settings specified here should match the protocol that the 
CP2/CP2E expects. The settings are as follows: 

•  Port = COM 1 through COM 8. Select the correct COM port on the PC. 
•  Baud rate = 115200 (You can set the PC and the control system to a 

different baud rate, by using the Functions | Set Baud Rate command. 

•  Parity = None. 
•  Number of data bits = 8. 
•  Number of stop bits = 1. 

•  2-Series Integrated Control Processor: CP2/CP2E