Mitsumi electronic MR-J3- A Manual De Usuario

 

 

1 -  12 

1. FUNCTIONS AND CONFIGURATION 

 
1.7 Structure 

1.7.1 Parts identification 

(1) MR-J3-100A or less 

MODE

UP

DOWN

SET

Main circuit power supply connector (CNP1)
Connect the input power supply.

USB communication connector (CN5)
Connect the personal computer.

Analog monitor connector (CN6)
Outputs the analog monitor.

RS-422 communication connector (CN3)
Connect the personal computer.

Control circuit connector (CNP2)
Connect the control circuit power supply/regenerative 
option.

I/O signal connector (CN1)
Used to connect digital I/O signals.

Charge lamp
Lit to indicate that the main circuit is charged. While
this lamp is lit, do not reconnect the cables.

Encoder connector (CN2)
Used to connect the servo motor encoder. 

Battery holder
Contains the battery for absolute position data backup.

Battery connector (CN4)
Used to connect the battery for absolute position data 
backup.

Protective earth (PE) terminal (    )
Ground terminal.

Section 12.8

Section 3.2
Section 3.4

Section 12.8

Chapter 13

Section 3.2
Section 3.4

Section 3.4

Section 12.1

Section 12.9

Chapter 14

Section 14.3

Section 1.5

Fixed part
(2 places)

Servo motor power connector (CNP3)
Connect the servo motor.

Section 3.1
Section 3.3

Section 3.1
Section 3.3

Section 3.1
Section 3.3

Section 3.1
Section 3.3

Rating plate

Name/Application

Display
The 5-digit, seven-segment LED shows the servo 
status and alarm number.

Used to set data.

Used to change the
display or data in each
mode.

Used to change the
mode.

MODE

UP

DOWN

SET

Operation section
Used to perform status display, diagnostic, alarm and 
parameter setting operations.

Chapter 6

Chapter 6

Detailed 

explanation