Baby Trend 1956CT Manual De Usuario

1. Carefully remove stroller from the carton. Note: Front wheels, rear

wheels, child tray and parent tray

MUST

be installed before using.

2. Unfold stroller frame by sliding the

RED

thumb trigger to the left and

squeezing the

RED

pull trigger while pulling backward on the stroller

handle. (Fig. 1-2)

3. To attach the front wheels, lean the stroller back so that it rests on the

handle with the front and rear legs pointing upward. Position the front
wheels over the front leg tubes so that the hole in the housing lines
up and will slide onto the legs. (Fig. 3) Firmly push down until the
wheels lock securely into place. Tug on each wheel to ensure they are
both securely attached.

4. Attach the rear axle assembly and wheels as follows:

a. Position axle assembly over the rear leg tubes, brake pedals

facing the back. At the same time, push down applying equal
pressure to both sides until they lock into place. (Fig. 4)

b. Slide a wheel onto each side of the axle. (Fig. 5)
c. Secure both wheels using with a locking washer. Push locking

washer ﬁrmly in place. (Fig. 6a)

d. Cap axle end using the solid metal caps. (Fig. 6b)
e. Cover and ﬁnish using hubcaps. (Fig. 6c)

Pull on both wheels to ensure they are secure and can spin freely.
Note:

DO NOT

use stroller if wheels do not lock into place. If you

need assistance, please contact our customer service department at
(800) 328-7363, M-F, between 8am and 4:30pm, PST.

TO ENSURE SAFE OPERATION OF YOUR STROLLER, PLEASE

FOLLOW THESE INSTRUCTIONS CAREFULLY. RETAIN THESE

INSTRUCTIONS FOR FUTURE REFERENCE.

Fig. 3

PARTS

TO ASSEMBLE STROLLER

Child Tray

Solid Cap (2)

Locking Washer (2)

Rear Wheel (2)

Stroller

Fig. 1

Flex-Loc Base

Car Seat

Fig. 2

Rear Axle Assembly

Hub Cap (2)

Front Wheel (2)

Fig. 4

Parent Tray

Fig. 5