3com WX1200 3CRWX120695A Manual De Usuario
390
C
HAPTER
11: M
ANAGED
A
CCESS
P
OINT
C
OMMANDS
disable
— Disables link calibration packets for the MAP radio.
Defaults
—
Disabled.
Access
—
Enabled.
History
—
Introduced in MSS Version 6.0.
Usage
—
By default, RF load balancing is enabled on all MAP radios.
Use this
command to disable or re-enable RF load balancing for the
specified MAP radio.
RF load balancing can also be disabled or re-enabled globally with the set
load-balancing mode command. If RF load balancing has been enabled
or disabled for a specific MAP radio, then the setting for the individual
radio takes precedence over the global setting.
load-balancing mode command. If RF load balancing has been enabled
or disabled for a specific MAP radio, then the setting for the individual
radio takes precedence over the global setting.
Examples
—
The following command disables RF load balancing for
MAP radio 1 on
MAP 7:
WX# set ap 7 radio 1 load-balancing disable
WX#
See Also
set ap radio load
balancing group
balancing group
Assigns an MAP radio to a load balancing group.
Syntax — set ap ap-number radio {1 | 2} load-balancing group
name [rebalance]
name [rebalance]
ap ap-number
— Index value that indentifies the MAP on the WX.
radio 1
— Radio 1 of the MAP.
radio 2
— Radio 2 of the MAP. (This option does not apply to
single-radio models.)
group name
— Name of an RF load balancing group to which the
MAP radio
is assigned. A radio can belong to only one group.