Graco 117256 Series C Manual De Usuario

Network ID and Transceiver ID dipswitch settings are 
made on the PC board. To access the board, the trans-
ceiver cover must be removed.

1.

Remove power to the transceiver.

All dipswitch settings must be made without 
power to the transceiver.

When necessary to change dipswitch settings remove 
the transceiver cover by:

1.

Using a small screwdriver, push on the snap-locks 
(2) on one end of the Transceiver. See F

2.

At the same time, slightly lift cover on the corre-
sponding end of the Transceiver. 

3.

Repeat the process on the opposite side to remove 
the cover. 

4.

Set the appropriate dipswitch (S1 or S2). See F

5.

Replace the cover by snapping the cover back on.

6.

Labels with the letters A-H are provided with each 
Transceiver. These letters are applied to the outside 
of the Transceiver to identify its ID's. The first letter 

is the Network ID and the second letter is the Trans-
ceiver ID (i.e., AA).

Transceivers are often mounted above the work 
environment. With the labels applied to the 
diagnostic light side of the transceiver box, the 
technician can more easily understand the 
Matrix ID configuration.

2

2

S2

S1