Perlick HP15RS Manual De Usuario

7

Signature  Series (HP15 model)

Unit  may  tip  forward  if  loaded  racks/shelves  are  all  pulled 

out at the same time. To prevent tipping and provide a stable 

installation, the unit must be secured in place with the anti-tip 

brackets provided with the unit.

A set of metal anti-tip brackets and necessary hardware is supplied 
with the unit. The anti-tip brackets, when properly installed, should 
secure the rear legs and prevent the unit from tipping forward.

Some  installation  sites  may  require  modification  to  provide  a 
secure surface for attaching brackets. Refer to Figure 3 (below) for 
mounting bracket locations for 15” Signature Series models.

IMPORTANT  NOTE:  If  installing  on  a  concrete  floor,  concrete 
fasteners are required and are not included in the Anti-Tip Kit. 

Finished  flooring  should  be  protected  with  the  appropriate 

material to avoid damage from moving the unit.

If  unit  has  been  laid  on  its  back  or  sides,  place  unit  upright  and 
allow minimum of 24 hours before connecting power.

1. Plug in the unit into the 15 amp grounded outlet located 

in the installation opening. With power applied to the unit, 
check that the lighting and cooling function operate properly, 
then turn off power to the wall outlet at the circuit breaker.

Shut off power to the wall outlet before installing unit into the 

opening.

2. Check that the following are level and square:

• 

 front face and interior opening

• 

 installation opening and floor surface

• 

 countertop bottom front edge

IMPORTANT NOTE: The floor under the unit must be at the same 
level as the surrounding finished floor. 

3. If all surfaces are level, refer to Figure 4 (below) and perform 

the following:
a. Measure from the floor to the bottom of the front edge of 

the countertop.

b. Mesure the rear of the unit cabinet from floor to top of 

cabinet, at back corners.

c. Adjust rear legs so B measurement equals A measurement. 

Using an adjustable wrench or pliers, turn legs counter-
clockwise to raise the unit or clockwise to lower the unit. 

IMPORTANT  NOTE:  Leveling  legs  should  not  extend  more  than 
3/4” from bottom of the unit.

4. Slide cabinet into position. Make sure the rear levelling legs 

slide under the anti-tip brackets. Push the unit into the open-
ing until the bottom front edge of the unit is flush with the 
surrounding cabinetry, or until the rear legs are tight against 
the anti-tip brackets.