KitchenAid KBRA20ELBT0 Manual De Usuario

Descargar
Página de 52
6
4. To determine the length of copper tubing you will need, 
measure from connection on lower left rear of refrigerator to 
water pipe. Add 7 ft. (2.1 m) to allow for moving refrigerator 
for cleaning. Use 
¹⁄₄ in. (6.35 mm) O.D. (outside diameter) 
copper tubing. Be sure both ends of copper tubing are cut 
square.
5. Use a hammer and center punch to mark drilling location on 
water pipe. Using a grounded drill, drill a 
¹⁄₄ in. hole in the cold 
water pipe you have selected.
 
6. Fasten shutoff valve to cold water pipe with pipe clamp. Be 
sure outlet end is solidly in the 
¹⁄₄ in. drilled hole in the water 
pipe and that rubber washer is under the pipe clamp. Tighten 
packing nut. Tighten the pipe clamp screws carefully and 
evenly so rubber washer makes a watertight seal. Do not 
overtighten or you may crush the copper tubing, especially if 
soft (coiled) copper tubing is used. Now you are ready to 
connect the copper tubing.
7. Slip compression sleeve and compression nut on copper 
tubing as shown. Insert end of tubing into outlet end squarely 
as far as it will go. Screw compression nut onto outlet end 
with adjustable wrench. Do not overtighten.
8. Place the free end of the tubing into a bucket or sink. Turn ON 
main water supply and flush out tubing until water is clear. 
Turn OFF shutoff valve on the water pipe. Check for leaks. 
Coil copper tubing.
Connecting to Refrigerator
1. Remove plastic cap from water valve inlet port. Attach the 
copper tube to the valve inlet using a compression nut and 
sleeve as shown. Tighten the compression nut. Do not 
overtighten. Confirm copper tubing is secure by pulling on 
copper tubing.
2. Create a service loop using extreme care to avoid kinks. 
Secure copper tubing to refrigerator cabinet with a “P” 
clamp. 
3. Turn on water supply to refrigerator and check for leaks. 
Correct any leaks.
4. Plug in refrigerator or reconnect power.
5. Push refrigerator into opening.
Base Grille
Removing the base grille
1. Grasp the grille with both hands.
2. Pull up on the bottom and tilt it toward you.
3. Pull down to release the top of the grille.
Replacing the base grille
1. See markings on inside of base grille for proper placement.
2. Snap the top of the grille into place first.
3. Press down and in on the bottom of the grille until it snaps 
into place.
1. Cold Water Pipe
2. Pipe Clamp
3. Copper Tubing 
4. Compression Nut
5. Compression Sleeve
6. Shutoff Valve
7. Packing Nut
1
2
3
4
5
6
7
1. Copper Tubing
2. “P” Clamp
3. Compression Nut
4. Compression Sleeve
5. Water Valve Inlet Port
1
2
3
4
5