KitchenAid KFIS29BBMS Manual De Usuario

INSTALLATION INSTRUCTIONS

4. Install the water supply tube clamp around the water supply 

line to reduce strain on the coupling.

5. Turn shutoff valve ON.

6. Check for leaks. Tighten any connections (including 

connections at the valve) or nuts that leak.

7. On some models, the ice maker is equipped with a built-in 

water strainer. If your water conditions require a second water 
strainer, install it in the 

¹⁄₄" (6.35 mm) water line at either tube 

connection. Obtain a water strainer from your appliance 
dealer.

1. Plug into a grounded 3 prong outlet.

2. Flush the water system. See “Water and Ice Dispensers.”

NOTE: Allow 24 hours to produce the first batch of ice. Discard 
the first three batches of ice produced. Allow 3 days to 
completely fill the ice storage bin. 

Parts Included: Door handles (2), Drawer handle(s) (1 or 2 
depending on model), 

¹⁄₈" hex key, spare setscrew(s) 

NOTE: With the handles laying on a flat surface, the handles 
intended for the drawers are more curved. They will not mount 
flush against the doors. 

NOTE: Handle mounting setscrews are preinstalled inside the 
handle.

1. Remove the handles from the packaging inside the 

refrigerator, and place them on a soft surface.

2. Open a refrigerator compartment door. On the closed door, 

place a handle onto the shoulder screws so that the 
setscrews are facing the adjacent door.

3. Firmly push the handle toward the door until the handle base 

is flush against the door. 

4. While holding the handle, insert the short end of the hex key 

into the upper hole and slightly rotate the hex key until it is 
engaged in the setscrew. 

5. Using a clockwise motion tighten the setscrew just until it 

begins to contact the shoulder screw. Do not fully tighten. 

6. Repeat steps 4 and 5 to fasten the lower setscrew.

7. Once both setscrews have been partially tightened as 

instructed in the previous steps, fully tighten both setscrews.    

IMPORTANT: When the screws feel tight, tighten them an 
additional quarter-turn. The handle is not properly installed 
without this extra tightening.

A

B