KitchenAid KFIS29BBMS Manual De Usuario

REFRIGERATOR USE

4. When 1 cup of water has been correctly dispensed into the 

measuring cup, press the MEASURED FILL button under the 
word “Confirm” to confirm the calibration.  

5. When Measured Fill calibration has been confirmed the icons 

will disappear and the display will return to the home screen.

IMPORTANT: 

■

Dispense at least 1 qt (1 L) of water every week to maintain a 
fresh supply.

■

If the flow of water from the dispenser decreases, it could be 
caused by low water pressure. 

■

With the water filter removed, dispense 1 cup (237 mL) of 
water. If 1 cup (237 mL) of water is dispensed in 
8 seconds or less, the water pressure to the refrigerator 
meets the minimum requirement.

■

If it takes longer than 8 seconds to dispense 1 cup 
(237 mL) of water, the water pressure to the refrigerator is 
lower than recommended. See “Water Supply 
Requirements” and “Troubleshooting” for suggestions.

1. Press a sturdy glass against the dispenser paddle.

2. Remove the glass to stop dispensing

Measured Fill allows you to dispense a specified amount of water 
with the touch of a few buttons. 

NOTE: The amount of water you select will be dispensed. Make 
sure the container is empty and that it can hold the entire volume. 
If ice is in the container, you may need to adjust your selection.

1. Press MEASURED FILL to turn the feature on. When the 

feature is on, the Measured Fill screen appears on the display. 

Press ICE MODE, under Back, to manually turn off the 
Measured Fill feature and return to the home screen.

NOTE: The dispenser will automatically turn off Measured Fill 
after 1 minute of inactivity. When Measured Fill is turned off, 
any changes you have made will be lost and all defaults will 
be restored.

2. You can dispense water by the ounce, cup, or liter. The 

default unit is ounces. To switch to cups or liters, press the 
LIGHT button under Units.

Default, minimum, and maximum volumes are listed in the 
following chart:

3. Press the LOCK (+) and OPTIONS (-) buttons to adjust the 

volume as desired. The LOCK button increases the volume, 
and the OPTIONS button lowers the volume.

NOTES: 

■

When increasing or decreasing the dispense volumes, if 
an adjustment button (-/+) is held for approximately 
10 seconds or longer the control may stop responding. 
Release the button for approximately 2 seconds and then 
continue making the adjustment.

■

Most coffee cups (commonly 4 to 6 oz [118 to 177 mL] 
per cup) are not the same size as a measuring cup (8 oz 
[237 mL]). You may need to adjust the volume to avoid 
unintentionally overfilling coffee cups. 

4. To dispense water, press a sturdy glass against the water 

dispenser lever OR place the glass below the water dispenser 
and press the MEASURED FILL button.

NOTE: While dispensing water, the digital display will count 
down how much water remains to be dispensed, according 
to the volume you selected. The flow of water will 
automatically stop once the desired volume has been 
dispensed.

5. To stop dispensing before the selected volume has been 

dispensed, remove the glass from the dispenser lever OR 
press the MEASURED FILL button a second time.

NOTE: If you stop dispensing before the desired volume has 
been dispensed, the digital display will continue to show how 
much water remains to be dispensed. The display will turn off 
after 1 minute of inactivity.

6. To select a new volume or start dispensing the same volume 

again, you must first finish dispensing the selected volume, or 
turn off the Measured Fill feature (either by waiting 1 minute so 
it will automatically turn off or by pressing ICE MODE to 
manually turn it off) and then turn it back on.

A

Ounces

8

1

128

Cups

1

¹/₄

16

Liters

0.25

0.05

4.00