KitchenAid KSRF25FRBT00 Manual De Usuario

NOTE: Not all bulbs will fit your refrigerator. Be sure to replace the 
bulb with one of the same size, shape and wattage. On some 
models, the dispenser light requires a heavy duty 10-watt bulb. All 
other lights require a 40-watt bulb. Replacement bulbs are 
available from your dealer.
1. Unplug refrigerator or disconnect power.
2. Remove light shield when applicable. 

NOTE: To clean the light shield, wash it with warm water and 
liquid detergent. Rinse and dry the shield well.

3. Remove light bulb and replace with one of the same size, 

shape and wattage.

4. Replace light shield when applicable.
5. Plug in refrigerator or reconnect power.

■

Power cord unplugged? Plug into a grounded 3 prong outlet.

■

Is outlet working? Plug in a lamp to see if the outlet is 
working.

■

Household fuse blown or circuit breaker tripped? Replace 
the fuse or reset the circuit breaker. If the problem continues, 
call an electrician.

■

Are controls on? Make sure the refrigerator controls are on. 
See “Using the Controls.”

■

New installation? Allow 24 hours following installation for the 
refrigerator to cool completely.   

NOTE: Adjusting the temperature controls to coldest setting 
will not cool either compartment more quickly.

Your new refrigerator may run longer than your old one due to its 
high-efficiency compressor and fans. The unit may run even 
longer if the room is warm, a large food load is added, doors are 
opened often, or if the doors have been left open.

Refrigerator noise has been reduced over the years. Due to this 
reduction, you may hear intermittent noises from your new 
refrigerator that you did not notice from your old model. Below are 
listed some normal sounds with an explanation.

■

Buzzing - heard when the water valve opens to fill the ice 
maker

■

Pulsating - fans/compressor adjusting to optimize 
performance

■

Rattling - flow of refrigerant, water line, or from items placed 
on top of the refrigerator

■

Sizzling/Gurgling - water dripping on the heater during 
defrost cycle

■

Popping - contraction/expansion of inside walls, especially 
during initial cool-down

■

Water running - may be heard when water melts during the 
defrost cycle and runs into the drain pan

■

Creaking/Cracking - occurs as ice is being ejected from the 
ice maker mold.

■

Door blocked open? Move food packages away from door. 

■

Bin or shelf in the way? Push bin or shelf back in the correct 
position.

Are the gaskets dirty or sticky? Clean gaskets with mild soap 
and warm water.

■

Is a light bulb loose in the socket or burned out? See  
“Changing the Light Bulbs.”

■

Is the dispenser light set to ON? The dispenser light will 
operate only when the levers are pressed. If you want the 
dispenser light to stay on continuously, set the dispenser light 
to ON, or NIGHT LIGHT or AUTO. See “Water and Ice 
Dispensers.”