Burris LH 3 Manual De Usuario
Chapter 3
Conversion: Install Components, Cover, and Front Bezel
32
Install Chassis Retention Bracket when Shipping
an HP Rack
an HP Rack
For the HP rack, the rack nuts for the chassis retention bracket were installed on
the right rear rack column.
the right rear rack column.
For the HP rack, install the chassis retention bracket and secure the NetServer to
it, as follows:
it, as follows:
1. Position the bracket as shown in Figure 3-9.
Chassis Retention
Bracket
Bracket
Rack Nuts
Right Rear Column
of HP Rack
of HP Rack
Hole 13 above Base Line
Hole 9 above Base Line
Figure 3-9. Screw Bracket to Rack and NetServer (Shown for HP NetServer
LH 3r; Number of Power Supply Modules May Vary)
NOTE
The Chassis Retention Bracket is only required for shipping the
system in an HP rack.
system in an HP rack.
2. Fasten the bracket to the rack with the two 10x32 screws.
3. Fasten the bracket to the NetServer with the two 6x32 screws.
For the HP rack with an anti-tip foot, retract the anti-tip foot if other components
will not be extended from the front of the rack.
will not be extended from the front of the rack.