Compaq 230934-002 Manual De Usuario
Initial Configuration of the Switch
2-2
Modular SAN Array Fabric Switch 6 User Guide
COMPAQ CONFIDENTIAL
Writer: Kim L. Miller File Name: c-ch2 Initial Configuration of the Switch.doc
Codename: Millebourne Part Number: 230934-002 Last Saved On: 7/17/02 7:46 AM
Configuration Overview
When a switch is initially connected to a network, the network does not recognize it
and does not know its IP address. Accessing the switch and entering the Ethernet and
SNMP settings assigns the switch a location and makes it available to the network.
and does not know its IP address. Accessing the switch and entering the Ethernet and
SNMP settings assigns the switch a location and makes it available to the network.
After the switch is accessible, additional parameters must be entered. These
secondary configuration tasks can be performed from four different user interfaces,
including the text-based user interface (text-based UI), Command Line Interface
(CLI), the ACU-XE, and the Compaq MSA Fabric Switch 6 Management Utility.
secondary configuration tasks can be performed from four different user interfaces,
including the text-based user interface (text-based UI), Command Line Interface
(CLI), the ACU-XE, and the Compaq MSA Fabric Switch 6 Management Utility.
The text-based UI can be used for the initial configuration tasks and the CLI can be
accessed from this interface to perform advanced configuration tasks.
accessed from this interface to perform advanced configuration tasks.
The CLI of the switch provides access to extensive management and monitoring
functions and is available directly through the serial port in the front of the switch or
remotely through the switch’s Ethernet interface using telnet. During initial set-up, it
is accessed through the text-based UI. Subsequently, the system defaults to the CLI
or the text-based UI, depending on which interface was used last. For information on
the CLI, refer to Appendix C, “Command Line Interface.”
functions and is available directly through the serial port in the front of the switch or
remotely through the switch’s Ethernet interface using telnet. During initial set-up, it
is accessed through the text-based UI. Subsequently, the system defaults to the CLI
or the text-based UI, depending on which interface was used last. For information on
the CLI, refer to Appendix C, “Command Line Interface.”
The ACU-XE is a web-based user interface primarily used to configure the array
controllers and hard drive arrays of the MSA1000. In addition, the ACU-XE can be
used to configure the switch. Instructions for configuring the switch using the
ACU-XE are included in this chapter. For information on using the ACU-XE to
configure the storage, refer to the StorageWorks by Compaq Modular SAN Array
1000 User Guide or the Compaq Array Configuration Utility XE User Guide.
controllers and hard drive arrays of the MSA1000. In addition, the ACU-XE can be
used to configure the switch. Instructions for configuring the switch using the
ACU-XE are included in this chapter. For information on using the ACU-XE to
configure the storage, refer to the StorageWorks by Compaq Modular SAN Array
1000 User Guide or the Compaq Array Configuration Utility XE User Guide.
The MSA Fabric Switch 6 Management Utility provides most of the functions
available in the text-based UI and the CLI, but in a user-friendly, web-based,
graphical interface. It is accessible from Compaq Insight Manager (CIM-XE) or any
workstations equipped with a web browser. For more information, refer to
available in the text-based UI and the CLI, but in a user-friendly, web-based,
graphical interface. It is accessible from Compaq Insight Manager (CIM-XE) or any
workstations equipped with a web browser. For more information, refer to
www.compaq.com/storageworks
.