Cabletron Systems 3Com Manual De Usuario

For optimal performance, place wireless clients and APs away from transformers, 
heavy-duty motors, fluorescent lights, microwave ovens, refrigerators and other 
industrial equipment.

Signal loss can occur when metal, concrete, brick, walls or floors block transmission. 
Locate antennas in open areas or add additional APs as needed to improve coverage.

A site survey analyzes the installation environment and provides users with 
recommendations for the number and placement of APs. 3Com recommends that a 
site survey be conducted at any new site prior to installing AirConnect equipment. 

To improve AP management and performance, you should understand basic AP 
functionality and configuration options. The AP includes features for different 
interface connections and network management.

The AP provides MAC layer bridging between its interfaces. The AP monitors 
traffic from its interfaces and, based on frame address, forwards the frames to the 
proper destination. The AP tracks the frames sources and destinations to provide 
intelligent bridging as wireless clients roam or network topologies change. The AP 
also handles broadcast and multicast message initiations and responds to wireless 
client association requests.

The AP listens to all packets on all interfaces and builds an address database using 
the unique IEEE 48-bit address (MAC address). An address in the database includes 
the interface media that the device uses to associates with the AP. (The AP internal 
stack interface handles all messages directed to the AP.) The AP uses the database 
to forward packets from one interface to another. The bridge forwards packets 
addressed to unknown systems to the default interface (either Ethernet or PPP). 

Each AP stores information on destinations and their interfaces to facilitate 
forwarding. When you send an Address Resolution Protocol (ARP) request packet, 
the AP forwards the request over all enabled interfaces (Ethernet, PPP, or radio), 
except over the interface on which the ARP request packet was received. 
(Radio-received ARP request packets echo back to other APs over radio.) Upon 
receiving the ARP response packet, the AP database keeps a record of the 
destination address along with the receiving interface. With this information, 
the AP forwards any directed packet to the correct destination. The AP forwards 
packets for unknown destinations to the Ethernet interface.

The AP removes from its database destinations or interfaces not used for a 
specified time. The AP refreshes its database when it transmits or receives data 
from these destinations and interfaces.