Cabletron Systems 3Com Manual De Usuario
Navigating the UI
61
Configure the other settings as required on the AP. The table below explains the
other settings.
other settings.
Configuring the Dial-Up System
To configure the Dial-up System, (assuming the PPP, serial port, and answer mode
are enabled on the AP), follow the procedure below.
are enabled on the AP), follow the procedure below.
1 Attach a null-modem serial cable from the AP to the modem.
2 Verify the modem connects to the telephone line and has power. Refer to the
modem documentation for information on verifying device power.
3 Start the communication program from the remote terminal.
4 Select the correct serial port along with the following parameters:
■
Emulation—ANSI
■
Baud rate—19200 bps
■
Data bits—8
■
Stop bits—1
■
Parity—none
■
Flow control—none
5 Dial out to the AP with the appropriate telephone number. No password is required.
6 Press Esc to refresh the display.
The AP displays the Main Menu.
Hanging Up
To hang up from the UI while a call is still connected:
1 Select Special Functions from the Main Menu.
2 Select Modem Hangup.
Setting
Description
Answer Wait Time
The time waiting for a remote
connection before dropping the
attempt. The default is 60 seconds.
connection before dropping the
attempt. The default is 60 seconds.
Modem Speaker
AP sends a command to the modem to
turn on/off the modem speaker. The
default is On.
turn on/off the modem speaker. The
default is On.
Inactivity Timeout
The inactivity time on the UI that causes
the AP to terminate the connection
while using a modem. The default is 5
minutes. A value of zero indicates no
time-out.
the AP to terminate the connection
while using a modem. The default is 5
minutes. A value of zero indicates no
time-out.