3com 3CRWE776075 Manual De Usuario

 

32 Using SFP Transceivers

Figure 3   Inserting the SFP Transceiver 

3 Check the SFP Module Status LEDs on the front of the switch. The 

corresponding LED will light to indicate the SFP module is present.

4 Remove the plastic protective cover, if fitted.

5 Connect the fiber cable.

6 The transceiver connects to the network using a duplex LC connector. 

Attach a male duplex LC connector on the network cable into the duplex 
LC connector on the transceiver.

7 Connect the other end of the cable to a device fitted with an appropriate 

Gigabit Ethernet connection.

Removing an SFP transceiver does not require powering-off the switch.

To remove an SFP transceiver:

1 Disconnect the cable from the transceiver.

2 Move the wire release lever downwards until it is pointing toward you.

3 Pull the wire release lever toward you to release the catch mechanism.

4 The SFP transceiver should slide out easily.

Product
label

Suitable port
on host Switch