Cisco Systems ASA 5500 Manual De Usuario

ASDM includes a Startup Wizard to simplify the initial configuration of your 
adaptive security appliance. With a few steps, the Startup Wizard enables you to 
configure the adaptive security appliance so that it allows packets to flow securely 
between the inside network (GigabitEthernet0/1) and the outside network 
(GigabitEthernet0/0). 

To use the Startup Wizard to set up a basic configuration for the adaptive security 
appliance, perform the following steps: 

If you have not already done so, perform one of the following steps: 

If you have an ASA 5520 or 5540, connect the inside GigabitEthernet0/1 
interface to a switch or hub by using the Ethernet cable. To this same switch, 
connect a PC for configuring the adaptive security appliance.

If you have an ASA 5510, connect the inside Ethernet 1 interface to a switch 
or hub by using the Ethernet cable. To this same switch, connect a PC for 
configuring the adaptive security appliance.

Configure your PC to use DHCP (to receive an IP address automatically from the 
adaptive security appliance), or assign a static IP address to your PC by selecting 
an address out of the 192.168.1.0 network. (Valid addresses are 192.168.1.2 through 
192.168.1.254, with a mask of 255.255.255.0 and default route of 192.168.1.1.)

The inside interface of the adaptive security appliance is assigned 
192.168.1.1 by default, so this address is unavailable.

Perform one of the following steps: 

If you have an ASA 5520 or 5540, check the LINK LED on the 
GigabitEthernet0/1 interface. 

If you have an ASA 5510, check the LINK LED on the Ethernet 1 interface. 

When a connection is established, the LINK LED interface on the adaptive security 
appliance and the corresponding LINK LED on the switch or hub becomes solid 
green.

Launch the Startup Wizard.

On the PC connected to the switch or hub, launch an Internet browser.