Cisco Systems 8540 Manual De Usuario
C H A P T E R
4-1
Layer 3 Switching Software Feature and Configuration Guide
78-6235-04, Cisco IOS Release 12.0(10)W5(18)
4
Configuring Interfaces
This chapter describes basic interface configurations for your Layer 3 switch router. Also included are
sections about configuring virtual LANs (VLANs), packet-over-SONET interfaces, ATM uplink
interfaces, and port snooping.
sections about configuring virtual LANs (VLANs), packet-over-SONET interfaces, ATM uplink
interfaces, and port snooping.
Unless otherwise noted, the information in this chapter applies to the Catalyst 8540 CSR,
Catalyst 8510 CSR, and Catalyst 8540 MSR with Layer 3 functionality. For further information about
the commands used in this chapter, refer to the command reference publications in the Cisco IOS
documentation set and to Appendix A, “Command Reference.”
Catalyst 8510 CSR, and Catalyst 8540 MSR with Layer 3 functionality. For further information about
the commands used in this chapter, refer to the command reference publications in the Cisco IOS
documentation set and to Appendix A, “Command Reference.”
This chapter includes the following sections:
•
•
•
•
•
•
•
•
•
•
•
•
Note
You are at Step 3 in the suggested process for configuring your switch router (see the
“Suggested Procedure for Configuring Your Switch Router” section on page 2-1). You
should have already configured the processor module (and LAN emulation on the
Catalyst 8540 MSR) and now be ready to proceed with configuring interfaces.
“Suggested Procedure for Configuring Your Switch Router” section on page 2-1). You
should have already configured the processor module (and LAN emulation on the
Catalyst 8540 MSR) and now be ready to proceed with configuring interfaces.