TANDBERG D1320203 Manual De Usuario
TANDBERG 3G Gateway
Data port Command Interface User Guide
4.
The TANDBERG 3G Gateway Commands
4.1.
Introduction
Typing ‘?’ or ‘help’ when connected to the Data Port Command Interface will return a list of valid
commands. The commands are used to control the functions of the 3G Gateway. A command may be
followed by a set of parameters and sub-commands. This chapter gives a description of all valid commands
for the 3G Gateway.
commands. The commands are used to control the functions of the 3G Gateway. A command may be
followed by a set of parameters and sub-commands. This chapter gives a description of all valid commands
for the 3G Gateway.
4.1.1. Command format
Typing ‘?’ or ‘help’ after a command will result in a usage text (*h of help response) being displayed. Usage
text gives information about the command format, i.e. valid parameters, sub-commands etc. An example is
shown below (the user input is shown in bold).
text gives information about the command format, i.e. valid parameters, sub-commands etc. An example is
shown below (the user input is shown in bold).
Xconf DialPlan Entry 1 NetType ?
*h xConfiguration Dialplan Entry [1..64] NetType: <All/H324m/H323/SIP>
"Specifies the type of network to listen for incoming connections."
Numbers 1-64 and All/H324m/H323/SIP are parameters of the configuration (Xconf) command. Parameters
are arguments on which the command will operate upon. Required parameters are denoted by: < >, while
optional parameters are denoted by: [ ]. All possible values for given parameters are separated with slashes (
/ ). For some parameters, only their names are supplied within the brackets. In these cases specific parameter
values need to be substituted for the parameter names. Allowed parameter values, unless obvious, are
provided when the commands are discussed.
are arguments on which the command will operate upon. Required parameters are denoted by: < >, while
optional parameters are denoted by: [ ]. All possible values for given parameters are separated with slashes (
/ ). For some parameters, only their names are supplied within the brackets. In these cases specific parameter
values need to be substituted for the parameter names. Allowed parameter values, unless obvious, are
provided when the commands are discussed.
Sub-commands are commands grouped together within a command. Different sub-commands within a
command may have different parameter sets. In the example below: Address and Authentication are sub-
commands to the command H323Gatekeeper. In the same sense Mode, ID and Password are sub
commands of H323Gatekeeper Authentication.
command may have different parameter sets. In the example below: Address and Authentication are sub-
commands to the command H323Gatekeeper. In the same sense Mode, ID and Password are sub
commands of H323Gatekeeper Authentication.
xconf H323Gatekeeper ?
*h xConfiguration H323Gatekeeper Address: <IPAddr>
*h xConfiguration H323Gatekeeper Authentication Mode: <Auto/Off>
*h xConfiguration H323Gatekeeper Authentication ID: <S: 0, 50>
*h xConfiguration H323Gatekeeper Authentication Password: <S: 0, 50>
NOTE! The Data port Command Interface is not case sensitive.
D1320203
7