Global Technology Associates GBWA200501-01 Manual De Usuario

GB-Ware Firewall Product Guide

16

It may take several minutes for the runtime to install. A pipe indicator 
(|) will be animated while the system installs. A message similar to the 
following will display when the system installation is complete:

Loading runtime image for 

 – succeeded 

Initializing disklabel for da0 – succeeded

Initializing runtime slice 2 – succeeded

Initializing runtime slice 1 – succeeded

Your Compact Flash disk or hard disk should now have GB-Ware firewall 
software installed. Remove the GNAT Box System installation CD and 
press 

 to reboot. Power off the computer.

If you have installed GB-Ware using a proxy computer, remove the GB-
Ware disk from the computer and install it as the boot disk on the intended 
firewall. 

See the Appendix for instructions on installing a Compact Flash card 
and Compact Flash IDE adapter on your intended firewall.

If you installed GB-Ware using a proxy computer, restore the BIOS boot 
settings to the computer and re-connect any drives you may have discon-
nected during GB-Ware installation.

Attaching the Hardware Key Block
After installing the GB-Ware Compact Flash card or hard drive, but before 
initial configuration, plug the hardware key block (USB or parallel) into 
your GB-Ware firewall.

Without the key block, the software will operate in an unregistered  
mode during which the system is operational for only 60 minutes.

GTA's hardware key block is different from other key blocks because it is 
attached only to the GB-Ware firewall and not to client computers. The key 
block also provides freedom to upgrade or change system hardware: simply