Compaq 164SX Manual De Usuario
AlphaPC 164SX Switch Configuration
3–1
3
AlphaPC 164SX Switch Configuration
The AlphaPC 164SX motherboard has a switchpack located at SW1, as shown
previously in Figure 2–1. These switches set the hardware configuration. Figure 3–1
shows these switch configurations.
previously in Figure 2–1. These switches set the hardware configuration. Figure 3–1
shows these switch configurations.
3.1 Mini-Debugger (CF3)
The Alpha SROM Mini-Debugger is stored in the flash ROM and is enabled/
disabled by switch CF3. The default position for this switch is on (see Figure 3–1).
When this switch is off, it causes the SROM initialization to trap to the Mini-
Debugger after all initialization is complete, but before starting the execution of the
system flash ROM code.
disabled by switch CF3. The default position for this switch is on (see Figure 3–1).
When this switch is off, it causes the SROM initialization to trap to the Mini-
Debugger after all initialization is complete, but before starting the execution of the
system flash ROM code.
3.2 CPU Speed Selection (CF[6:4])
The clock synthesizer at U45 makes it possible to change the frequency of the
microprocessor’s clock output. The switch configuration is set in SW1, CF[6:4].
These three switches set the speed at power-up as listed in Figure 3–1. The
microprocessor frequency divided by the ratio determines the system clock
frequency.
microprocessor’s clock output. The switch configuration is set in SW1, CF[6:4].
These three switches set the speed at power-up as listed in Figure 3–1. The
microprocessor frequency divided by the ratio determines the system clock
frequency.
3.3 Fail-Safe Booter (CF7)
The fail-safe booter provides an emergency recovery mechanism when the primary
firmware image contained in flash memory has been corrupted. When flash memory
has been corrupted, and no image can be loaded safely from the flash, you can run
the fail-safe booter and boot another image from a diskette that is capable of repro-
gramming the flash.
firmware image contained in flash memory has been corrupted. When flash memory
has been corrupted, and no image can be loaded safely from the flash, you can run
the fail-safe booter and boot another image from a diskette that is capable of repro-
gramming the flash.
Refer to Section 8.4 for more information.