Hearth & Home Technologies MBK Manual De Usuario
Page 3
Yosemite Wood Stove
7004-187F September 1, 2008
R
SERIAL NUMBER LABEL LOCATION .....................2
PRE-USE CHECKLIST ..............................................3
LISTINGS & SAFETY NOTICES ...............................4
INSTALLATIONS MATERIAL NEEDED FOR SAFETY 4
DIMENSIONS & VENT SPECIFICATIONS ................5
CLEARANCES
Top & rear vent installations .................................6
Floor
protection
....................................................7-8
INSTALLATION
Locating your stove ..............................................9
Leg leveling system .............................................9
Side door locking mechanism ..............................9
Reversible flue collar ............................................10
Horizontal heat shield ..........................................10
Chimney height requirements & Draft ..................11
2-10-3
Rule
..........................................................11
Flue
systems
........................................................11
TABLE OF CONTENTS
PRE-USE CHECK LIST
WARNING!
DO NOT TILT THE UNIT ON THE CAST IRON
LEGS. Lift the unit upright and place it into position
on the floor protector.
LEGS. Lift the unit upright and place it into position
on the floor protector.
1
Place the unit in a location near the final installation
area and follow the procedures below:
2
Open the stove and remove all the parts and articles
packed inside. Inspect all the parts and cast iron
body for shipping damage. Contact your dealer if
any irregularities are noticed.
body for shipping damage. Contact your dealer if
any irregularities are noticed.
3.
All safety warnings have been read and followed.
4.
This Owner’s Manual has been read.
5.
Floor protection requirements have been met.
6.
Chimney connector is properly installed.
7.
The proper clearances from the stove and chimney
to combustible materials have been met.
8.
The masonry chimney is inspected by a profes-
sional and is clean, or the factory built metal chim-
ney is installed according to the manufacturer’s
instructions and clearances.
ney is installed according to the manufacturer’s
instructions and clearances.
9.
The chimney meets the required minimum height.
10.
All labels have been removed from the glass
doors.
11.
11.
Plated surfaces have been wiped clean.
Chimney
connector
..............................................11
Masonry
chimney
.................................................12
Solid pack chimney with Metal supports
as a thimble ..........................................................13-14
Masonry fireplace .................................................14
Metal prefabricated chimney ................................15
Mobile home installation ......................................16
Outside air kit installation .....................................17
Blower
installation
................................................17
OPERATION
Over-firing your appliance ....................................18
Burning
process
...................................................18
Air
controls
...........................................................19
Heat output setting ...............................................20
Building a fire .......................................................20
Correct baffle & blanket placement ......................21
Opacity
.................................................................22
Burn
rates
............................................................22
Wood selection and storage.................................22
Blower operating instructions ...............................22
MAINTENANCE
Creosote formation & removal .............................23
Chimney
cleaning
................................................23
Ash
removal
.........................................................23
Glass care & replacement ....................................23-24
Care & cleaning of plated surfaces.............................24
Door handle assembly & door gasket ..................24
Brick
replacement
................................................25
Baffle removal & installation .................................25
Service & Maintenance Log .................................26
EXPLODED VIEWS ...................................................27
SERVICE PARTS .......................................................28
WARRANTY ...............................................................30
CONTACT INFORMATION ........................................32
TABLE OF CONTENTS
(Cont'd)