Cisco Systems PA-MC-8TE1 Manual De Usuario
l2protocol-tunnel point-to-point
To enable point-to-point protocol tunneling, use the l2protocol-tunnel point-to-point command in interface
configuration mode. To disable, use the no form of this command.
configuration mode. To disable, use the no form of this command.
l2protocol-tunnel point-to-point [pagp| lacp| udld]
no l2protocol-tunnel point-to-point [pagp| lacp| udld]
Syntax Description
(Optional) Enables port aggregation on a
point-to-point protocol tunneling.
point-to-point protocol tunneling.
pagp
(Optional) Enables link aggregation on a
point-to-point protocol tunneling.
point-to-point protocol tunneling.
lacp
(Optional) Enables a unidirectional link dectection
on a point-to-point protocol tunneling.
on a point-to-point protocol tunneling.
udld
Command Default
If no keyword is selected, tunneling is enabled for all three protocols.
Command Modes
Interface configuration (config-if)
Command History
Modification
Release
This command was introduced.
15.2(2)T
Usage Guidelines
To avoid a network failure, make sure that the network is a point-to-point topology before you enable tunneling
for PAgP, LACP, or UDLD packets.
for PAgP, LACP, or UDLD packets.
Examples
The following example shows how to enable link aggregation on a point-to-point protocol tunneling:
Router(config-if
)# l2protocol-tunnel point-to-point
)# l2protocol-tunnel point-to-point
lacp
Related Commands
Description
Command
Displays the enabled protocols and their values.
show l2protocol-tunnel
Cisco IOS Interface and Hardware Component Command Reference
14
l2 vfi manual through loopback PA-MC-8TE1 + port adapter
l2protocol-tunnel point-to-point