Clifford 570.4X Manual De Usuario

28

© 2011 Directed Electronics. All rights reserved.

28

Pair Remote:

Remote Pair is a process where the Responder LC and the system in 
the vehicle learn each others encrypted identification, securing their 
communication from intruders. Please note that your remote controls 
come pre-programmed from the factory.

Prepare the vehicle system to be Paired with a new remote
1.  Open at least one of the vehicle’s doors.
2.  Turn the key to the On position. 
3.  Within 5 seconds press and release 1 time the Control button on 

the Control Center.

4.  Within 5 seconds, press and hold the Control button. The status 

LED will flash one time and the siren will chirp once to confirm the 
system is ready for remote pairing.

5.  Release the Control button and proceed below.
Note: If pairing does not result within 60 seconds, the system will exit 
and the siren will chirp.

Prepare the new remote to be Paired with the system
1.  Make sure the remote control is set for the desired Car 1 or Car 

2 operation.

2.  Perform the steps under Access menu items section to access the 

Pair Remote mode.

3.  When the remote beeps 3 times and 

 is displayed the 

remote is ready to pair.

4.  Press and hold the 

button, the siren will chirp once and 

the remote will emit several tones to confirm successful pair-
ing. 

 is displayed and the remote returns to the main 

menu.

Note: 

 will be displayed and the remote will stay in the pair 

mode in case of an unsuccessful pairing. Check the system status and 
try again.