Honeywell VRX180 Manual De Usuario

To program Analog Inputs, select PROGRAM ANALOG INPUTS on the Main Program Menu.  Select an 
AI to program. 

 

INPUT ALGORITHM 

Standard or Custom 

This prompt appears only if “CUSTOM INPUT” is 
enabled under Enable Features in the Program 
Mode Menu (Section 0).  If “CUSTOM INPUT” is 
disabled you will see the Standard prompts (Table 
4-6). 

Standard lets you choose a thermocouple, RTD, 
EMF, or pyrometer type.  The Standard prompts 
are shown in Table 4-6.   

Custom lets you convert the input from a 
thermocouple or EMF to engineering units using a 
custom curve containing up to 20 points. 

Table 4-6 describes all the prompts associated with the standard algorithm.  These are the default 
prompts for analog input programming.  See Table 4-2 for additional prompts. 

 

INPUT TYPE 

See Table 1-3 for selections. The 
default type is OFF. 

Input type (thermocouple, RTD, pyrometer) 

RANGE LOW 

The value must be within the limits 
specified for the input type (see Table 
1-3). Be sure to use the correct value 
for the temperature units used (°F, °C, 
K, °R).  To enter the full range for the 
temperature units selected (see 
TEMPERATURE UNITS), select TYPE 
again and press Enter without changing 
the range type. 

Low end of the input range. 

RANGE HIGH 

The value must be within the limits 
specified for the input type (see Table 
1-3). Be sure to use the correct value 
for the temperature units used (°F, °C, 
K, °R).  To enter the full range for the 
temperature units selected (see 
TEMPERATURE UNITS), select TYPE 
again and press Enter without changing 
the range type. 

High end of the input range.