MicroNet Technology SP5054A/S Manual De Usuario

 

34

 

Configure the Hotline, Hunt and No Answer Forward 
--------------------------------------------------------------- 

usr/config$ line 
Gateway line information and configuration 
Usage: 
line -config number [hunt number][hotline number] 
line -print        Gateway line information. 
      hunt       Hunting group. 
      hotline     Hot line configuration. 
      fwdtype    forward type. 
                                  To IP: 
                                                0:disable 
                        1:un condition 
                                                2:busy 
            forward        forward. 
Example: 
          line -config 1 hunt 1 hotline 1003 forward1002 

--------------------------------------------------------------- 
Parameter Usages:   

-print   

 

print out all current settings of line   

-config     

determine which line to configure   

-hunt   

 

set hunting group flag of each line.   

User can assign different hunt group number represent 

different hunt group. For example, if user assigns FXS TEL1 

as hunt group 1, and FXS TEL2 as hunt group 2, they will be 

determined as 2 different groups. On the other hand, if user 

assigns FXS TEL1 as hunt group 1, and FXS TEL2 as hunt 

group 1 too, when having incoming call to FXS TEL1, which is 

busy, this call will be route to FXS Line2. Note: FXO Lines 

and FXS TELs are treated as 2 different groups, so even they 

are in the same hunt group, call will only be routed to the 

same FXS or FXO Lines. 

-hotline   

set hotline table.   

The Hotline Mode is applied to the gateway will automatically 

dial out a phone number. In the other hand, user will hear ring 

back tone or dial tone immediately depended on 

configurations of destination device.