Cisco Systems ata 186 Manual De Usuario
5-27
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide for MGCP (version 3.0)
OL-4803-01
Chapter 5 Parameters and Defaults
Operational Parameters
OpFlags
Description
Enables/disables various operational features.
See
for bit definitions of this parameter.
Value Type
Bitmap
Default
0x2
Voice Configuration Menu Access Code
323
Table 5-4
OpFlags Parameter Operational Features to Turn On or Off
Bit Number
Definition
0
If Bit 0 = 0, the TFTP configuration filename supplied by the DHCP server overwrites the default filename for
each Cisco ATA.
each Cisco ATA.
If Bit 0 = 1, the default Cisco ATA filename is always used.
Default: 0
1
If Bit 1 = 0, the Cisco ATA probes the static network router during the power-up process.
If Bit 1 = 1, static network router probing is disabled.
Default: 1
2
Reserved.
3
If Bit 3=1, the Cisco ATA does not request DHCP option 150 in the DHCP discovery message; some DHCP
server do not respond if option 150 is requested.
server do not respond if option 150 is requested.
Default: 0
4
If Bit 4 = 1, the Cisco ATA uses the VLAN ID specified in the VLANSetting parameter for VLAN IP encapsulation
(see the
(see the
).
Default: 0
5
If Bit 5=1, the Cisco ATA does not use VLAN IP encapsulation.
Default: 0
6
If Bit 6=1, the Cisco ATA does not perform CDP discovery.
Default: 0
7
If Bit 7=1, the Cisco ATA does not allow web-based configuration.
Default: 0
8
If Bit 8=1, the Cisco ATA does not allow HTTP refresh access with the http://ip/refresh command.
Default: 0
9
If Bit 9=1, the Cisco ATA does not allow HTTP reset access with the http://ip/reset command.
Default: 0