Cisco Systems 188 Manual De Usuario
5-23
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide (SIP)
OL-3410-01
Chapter 5 Parameters and Defaults
Operating Parameters
CallFeatures
Description
Disable/enable CallFeatures by setting each corresponding bit to 0 or 1.
The lower 16 bits are for the Phone 1 port, and the upper 16 bits are for the Phone 2 port.
provides definitions of each bit.
Note
The subscribed features that can be permanently disabled by the user are CLIP_CLIR, call waiting and
Fax mode. A subscribed service enable/disabled by the user can be disabled/enabled dynamically on a
per-call basis.
Fax mode. A subscribed service enable/disabled by the user can be disabled/enabled dynamically on a
per-call basis.
Value Type
Bitmap
Default
0xffffffff
Voice Configuration Menu Access Code
314
Table 5-2
CallFeatures Parameter Bit Definitons
Bit
Number
Number
Definition
0
Forward unconditionally
1
Forward on busy
2
Forward on no answer
3
CLIP_CLIR
4
Call waiting
5
three-way calling
6
Blind transfer
7
Transfer with consultation. This service allows the user to transfer the remote party to a different number by first
calling that number and consulting with the callee.
calling that number and consulting with the callee.
8
Caller ID. This service enables the Cisco ATA 186 to generate a Caller ID signal to drive a Caller ID display
device attached to the FXS line.
device attached to the FXS line.
9
Call return
10
Message waiting indication
11
Call Waiting Caller ID. This is available only if the Method bit in CallerIdMethod is set to Bellcore (FSK).
15
Fax mode. This service allows the user to set the Cisco ATA to Fax mode on a per-call basis. For Fax mode, use
the following settings:
the following settings:
•
G711 codec only
•
No silence suppression
•
No FAX tone detection