Cisco Systems 186 Manual De Usuario
5-28
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide (SIP)
OL-3410-01
Chapter 5 Parameters and Defaults
Operating Parameters
ConnectMode
Description
This parameter is a 32-bit bitmap used to control the connection mode of the selected call signaling
protocol.
protocol.
provides bit definitions for this parameter.
Value Type
Bitmap
Default
0x00060400
Voice Configuration Menu Access Code
311
Table 5-4
ConnectMode Parameter Bit Definitions
Bit Number
Definition
0—H.323 only
0—Enable normal start.
1—Enable fast start.
1—H.323 only
0/1—Disable/enable h245 tunneling.
2
0—Use the dynamic payload type 126/127 as the RTP payload type (fax pass-through mode) for G.711
µ-law/G.711 A-law.
µ-law/G.711 A-law.
1—Use the standard payload type 0/8 as the RTP payload type (fax pass-through mode) for G.711
µ-law/G.711 A-law.
µ-law/G.711 A-law.
3—H.323 only
0/1—Disable/enable the requirement for the alternate gatekeeper to register.
4—H.323 only
0—Denotes a non-Cisco CallManager environment.
1—Enable the Cisco ATA to operate in a Cisco CallManager environment.
5—H.323 only
0/1—Enable/disable two-way cut-through of voice path before receiving CONNECT message.
6—H.323 only
0/1—Disable/enable using the Progress Indicator to determine if ringback is supplied by the far end with
RTP.
RTP.
7
0/1—Disable/enable fax pass-through redundancy.
8-12
Specifies the fax pass-through NSE payload type. The value is the offset to the NSE payload base number
of 96. The valid range is 0-23; the default is 4.
of 96. The valid range is 0-23; the default is 4.
For example, if the offset is 4, the NSE payload type is 100.
13
0—Use G.711µ-law
for fax pass-through codec.
1—Use G.711A-law for fax pass-through codec.
14-15
0—Use fax pass-through.
1—Use codec negotiation in sending fax.
2—Reserved.
3—Reserved.
16—SIP only
0/1—Disable/enable SIP to remove the registration before adding a new one.