Braun 5 Manual De Usuario

Page 5

Resecure, replace or correct as needed.

Remove pump module cover and inspect: 

•  Hydraulic hoses, fittings and connections for wear 

or leaks 

•  Harness cables, wires, terminals and connections 

for securement or damage

•  Control board, circuit breaker, power switch and 

lights for securement or damage

Resecure, replace or correct as needed

Use Braun 32840-QT (Exxon

®

 Univis HVI 26) 

hydraulic fluid (do not mix with Dextron III or other 

hydraulic fluids).  Check fluid level with platform 

lowered fully and roll stop unfolded fully.  Fill 

to within 1/2” of the bottom of the 1-1/2” fill tube 

(neck).

Tighten, repair or replace if needed. 

 

 

Tighten, repair or replace if needed.

 

Replace if needed. 

Tighten or replace if needed.

Replace defective parts and resecure as needed.  

Apply Light Grease during reassembly procedures.

Replace if needed.

Tighten, replace or correct as needed 

Apply Door-Ease or replace if needed.  See Lubri-

cation Diagram.

 

Resecure or replace if needed.     

Resecure, repair or replace if needed.

Check to see that the lift is securely anchored to 

the vehicle and there are no loose bolts, broken 

welds, or stress fractures.

Replace decals if worn, missing or illegible.  Re-

place antiskid if worn or missing.  

Repeat all previously listed inspection, lubrica-

tion and maintenance procedures at 750 cycle 

intervals.

Inspect cotter pins on platform pivot pin (2)

Hydraulic Fluid (Pump) - Check level.  Note:  Fluid 

should be changed if there is visible contamination.  

Inspect the hydraulic system (cylinder, hoses, fit-

tings, seals, etc.) for leaks if fluid level is low.

Inspect cylinders, fittings and hydraulic connections 

for wear, damage or leaks 

Inspect outer barrier cylinder hose assembly (hose, 

fasteners, connections, etc.) for wear, damage or 

leakage

Inspect parallel arms, bushings and pivot pins for 

visible wear or damage

Inspect parallel arm pivot pin mounting bolts (8)

Inspect platform pivot pin, bushings and vertical 

arms for wear, damage and positive securement

Inspect upper/lower fold arms, rotating pivot slide 

arms, slide support arms and associated pivot pins, 

bushings, and bearings for visible wear or damage

Inspect gas springs (cylinders) for wear or damage, 

proper operation and positive securement (IB)

Inspect rotating pivot slide arm UHMW slide bear-

ings (buttons - 2) and UHMW slide ()

Inspect vertical arm plastic covers        

Inspect power cable 

 

 

Mounting 

 

 

 

 

 

 

Decals and Antiskid