Whirlpool 220/240-volt Manuales de usuario

Tabla de contenidos

• front cover

  1
• before you start

  2
• tools needed for installation

  2
• parts supplied for installation

  2
• electrical requirements

  2
• recommended earthing method

  2
• now start

  3
  • 1 - read and remove the label covering the drain connector

    3
  • 2 - insert flat washer into each end of inlet hoses

    3
  • 3 - attach hose to bottom valve first then top

    3
  • 4 - to prevent drain hose from coming off install per instructions

    3
  • 5 - open clamp and slide over hook end of drain hose

    3
  • 6 - move washer close to final position

    3
  • 7 - do not force excess drain hose down standpipe

    3
  • 8 - before attaching water inlet hoses run water through faucets

    3
  • 9 - attach bottom hose to hot water faucet

    3
  • 10 - carefully tilt washer backwards and brace with a piece of wood

    4
  • 11 - use legs and nuts from parts package

    4
  • 12 - insert legs into correct holes at each front corner

    4
  • 13 - tilt washer backward and remove wood block

    4
  • 14 - tilt washer forward to adjust rear self-leveling legs

    4
  • 15 - if washer is not level, adjust front legs

    4
  • 16 - cut shipping strap 15 inches from plug end

    4
  • 17 - check electrical requirements

    4
  • 18 - check that all parts are now installed

    4
  • 19 - turn on water faucets and check for leaks

    4
  • 20 - check that you have all of your tools

    4
  • 21 - untape power supply cord and plug into grounded outlet

    4
  • 22 - take a few minutes to read the use and care guide

    4
• recessed area instructions

  5
• if you need assistance

  5