Star Tech Development HDMIPATRN2EU Manuel D’Utilisation

3

Installation

1.  The video generator can be powered either by external power 

adapter or a 9V battery.  To access the battery compartment, flip the 

unit over and on the bottom side, will be the battery door.  Push in 

the small tab that secures the door and lift the door away from the 

unit.  

2.  Set the Video Resolution Switch to the desired output resolution for 

the display device (i.e. monitor, HDTV, etc) you wish to calibrate/test.

1080p/12

1080p @ 60Hz (12-bit)

1080p/10

1080p @ 60Hz (10-bit)

1080p/8

1080p @ 60Hz (8-bit)

1080i/8

1080i @ 60Hz (8-bit)

720p/10

720p @ 60Hz (10-bit)

720p/8

720p @ 60Hz (8-bit)

480p/8

480p @ 60Hz (8-bit)

3.  Connect the video generator to the display device using an HDMI 

cable or HDMI-to-DVI adapter/cable.  

4.  Set the Power Switch to the ON position, and the Power LED should 

light up solid.  If using battery power, then the battery becomes low, 

the LED will start to flash. 

5.  If the display device is HDCP compliant, than the HDCP Error LED 

should NOT light up.  If the LED lights up, then there is a problem 

with HDCP verification.