Datalogic Scanning D8330 Manuel D’Utilisation

POWERSCAN

®

 D8330/M8300 

cannot be successfully completed, then the code is added to the list. When the 
reader returns in range, transmission of the codes to the base station resumes 
automatically, according to the selected communication protocol, upon simply 
pressing and releasing the trigger or by successfully reading a new code. 

 

Each code is listed on the reader display together with its identifying position number 
and its total number of characters. The three keys under the display have the 
following function in batch mode: 

 

Key 

▲ 

(left) Key 

Scroll up in list 

ENTER

 

(center) Key 

Delete highlighted code 

▼ 

(right) Key 

Scroll down in list 

 
In batch mode, the selected Transmission Mode determines the behavior of the 
reader at the time the list of codes is transmitted. If One-way mode is enabled, the 
codes are transmitted one after the other without interruption. In Two-way mode, 
after transmitting each code, the reader waits for the Host answer message to be 
shown on the display. Therefore, in Two-way transmission mode and normal batch 
mode, the Start Normal Batch Transmission barcode must be read after each code 
to continue, whereas with automatic batch mode just pull and release the trigger after 
each code. 
 
The code, which has a transmission pending, is shown on the display in reverse 
video indicating that it cannot be deleted. 
 
 

®

 
If enabled, after a timeout of a few minutes in which PowerScan

®

 M8300 is not used, 

it enters stand-by mode and its green LED starts blinking in order to signal its 
location.